Ball Valve Drain Kit
The Do It Yourself Kit includes
1 Step Drill Bit
1 Brass Fitting 3/8″-1/2″
1 Stainless Ball Valve
*Drill required for DIY Installation.
We can install the drain kit at time of purchase if you select ‘Installed.’ We install drains center right side of the firebox.
Locate the area on the bottom of the firebox where you would like your drain to be located and remove the firebrick above that area.
Use the Step Drill Bit to drill a 7/8″ hole downward from the inside the firebox.
Install the Brass Fitting inside the firebox, and screw on the locking washer and brass nut underneath. Tighten.
Thread on the Ball Valve Drain until tight.